Change a Propane Tank
Propane powered forklifts are frequently used inside warehouses. The lift truck is designed with the propane tank mounted at the back of the operator. The tanks, that look much like beer kegs, have to be replaced every so often because they have a limited lifespan. Operators of forklifts should always utilize caution when handling propane tanks. Compressed gases are really hazardous, especially since the gas is flammable. Utilize caution when replacing and removing propane tank to prevent injury.
1 To change a propane tank, first stop the forklift while leaving the engine running, and turn the valve on the tank off. Let the lift truck run until the engine dies. This process burns off the gas in the transfer hose that connects the engine and the tank. Prior to taking the second steps, wear the proper safety equipment, like insulated gloves made of either leather or neoprene. It is really vital for you to protect your skin from contact with the compressed gas, which is very cold.
2 Disconnect the hose from the tank and take the holding straps off to remove the tank. When you put in a new tank, reconnect the holding straps and reattach the hose at the valve of the tank by tightening the nut.
3 Leaks could be checked simply by applying soapy water to the valve and slightly opening it. If there is a leak, it would cause bubbles to froth from around the valve. If this occurs, inspect the valve area and the connection hose at the nut. Re-tighten the connecting nut if you detect any leaks in the area of the valve, and then perform the leak inspection procedure all over again. Persistent leaks mean that both the connecting hose and nut should be replaced. Nonetheless, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Finally, open the valve all the way to enable the gas to fill the connecting hose. After that you could start the lift truck and resume working.