Inspect a Forklift
There are more than 10,000 workplace injuries related to forklifts happen each year, according to HRSDC and OSHA reports. Many of these accidents are caused by operator error. Lack of appropriate equipment maintenance and inspection causes many others. Maintenance and operation of a forklift is not just the reason for personal injuries, but also of property damage. Forklifts could damage sprinklers, building structures and overhead pipes, and other equipment when utilized wrongly. The following day by day inspections must be carried out so as to lessen the chance of forklift mishaps.
Before inspecting different fluid levels turn off the engine. Inspect these fluids: hydraulic oil, fuel, engine oil, brake fluid and coolant. The tires also need to be inspected for signs of wear and tear. Check the tire air pressure. Check the forks' condition. The load backrest must be attached firmly. Do a visual check of the top-clip retaining heel and pin. Afterward perform an inspection of the hydraulic hoses, mast chains, cables and stops. Ensure that both the finger and overhead guards are attached firmly.
The LP fueled forklift has propane tanks which need to be inspected for rust, corrosion or damage. The battery's charge and electrolyte levels need to be tested every so often. Seat belts have to be inspected for wear and tear. Check to make sure the owner's handbook is kept on-board the forklift inside a storage compartment. Test the seat belt to make sure the latches are secure. Test the hood latch to ensure it is working as it should.
To make certain there are no unusual engine sounds, start the engine up and listen for any irregularities. If there are, investigate promptly. Test the steering controls and the accelerator. The service brake and the parking break should be functioning properly.
To guarantee proper functioning in both reverse and forward, the drive control and tilt control should be inspected. The functioning of the lowering control, the hoist and attachment control requires periodic inspection. Test the lights and horn. Afterward check the wipers, heater and defroster to make sure they are functioning smoothly. Inspect each and every gauge to find out that it is reading within functional limits.