In the majority of situations, most individuals spend quite a bit of money buying their forklift. Therefore, it is very important to take good care of it so as to protect your investment well into the long run. It is really a great idea to know the procedures that are undertaken during maintaining and taking care of this machinery.
Among the best ways to tell how good the engine is working is by starting the forklift up and listening closely to see how it runs. For example, if there are any knocks or misses, the machinery is defective and this should raise several issues. Furthermore listen closely for any squealing noise that come from the belts since these noises would provide you with a wealth of information.
Some of the main components needing attention during maintenance comprise the gauges, horn, safety warning devices, the overhead guard and the lights. Any faulty parts or burnt out light bulbs have to be replaced as soon as they are noticed. It is also vital to check the wiring.
The battery compartment terminals must be cleaned after the above components have been checked thoroughly. If the terminals are not clean, be sure to clean them properly. Each battery cell should be inspected in order to make sure that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the equipment and then change the filters. The fuel filters, hydraulic filter and the transmission filter must be replaced on a regular basis. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
Once the oil change has been completed and new filters have been fitted, visually inspect the drive axle from beneath the machine. Be certain to grease the axle if there is any grease fitting. Inspect the belts on the engine for any frays or cracks. If you find any, fix the problem accordingly. After that, inspect each and every other part of the machinery including the wheels. If any type of concern or fault is detected, be certain to deal with it immediately so as to make certain the machine is working at its safest and optimum levels.